→

• Press and check the ENCODER box increases(Analog out +1 Volt)
• Press and check the ENCODER box decreases (Analog out -1 Volt)
• A - A' = The maximum space
• Take note of the start position (A)
• Zero-set the ENCODER:
• Move the axis from A to A'
• Take note of the reading in ENCODER box and write it in the PULSE box
• Measure the distance from A to A' = space delta
• Enter the A - A' space delta in the MEASURE box

Important:

• PULSE must alway be greater than MEASURE (the best is “MEASURE x 10 = PULSE”)
• Enter MEASURE in the selected unit measure. E.G. if a unit measure of 1/10mm is selected and the space delta is 133.5mm, enter 1335 in the MEASURE box